Modulator Bypass

Oftentimes after I setup a modulation I want to hear the dry sound again, usually because I want to isolate where a problem is occurring in the sound. It would be very handy in these cases to be able to temporarily disable a modulator on a specific control and then re-enable it later, without losing the amount setting. I’ve found it odd that most plugins don’t implement this, is it a particularly difficult task or am I just different? Is this something Current might do in the future?


Totally, this is on our radar after some more pressing updates. I don’t think it’s particularly hard but it would take some time to get it set up.

It’s not quite what you’re talking about but you can use the Level control on each modulator view to mute that modulator everywhere its assigned. Figured I’d throw that out there in case you find it useful.